LS-1-2
6-7
Quick, simple installation and all stainless
construction. Choice of thru
the cover or hidden under the cover for any LS type engine. Thru the cover lines have 26”" flex hose with SS female 06 AN ends. Under the cover lines have 40"” hoses; custom lengths and hose ends available upon request. See custom hose
section.
Price: 103.95 single line
kits
165.95 two line kits for
Installation instructions for
thru the cover lines:
Stainless compression fittings
attach your lines directly to the stock GM fuel rail. Slide the compression fitting on the GM
connector until the tubing bottom is in the fitting body and tighten according
to swedgelok fitting instructions which are included in this kit. The small clamp attaches the SS tubing
to the back of the driver side head; the large clamp can be used on the back of
the passenger side head, or a bell housing bolt. Leak check your
lines before starting your engine. (see leak check /disclaimer
info)
Under cover
lines
LS-1 and LS-6
Installation instructions for
under cover lines:
Slide the 90 degree compression fitting onto the fuel rail and follow the
swedgelok fitting instructions included with this kit. Complete your installation, pressurize
your fuel system, and check for leaks.
Remove your fuel rail from your intake. Using a tubing cutter cut the supply
line just behind the bead on the tube (see photo). Leave at least ¾"of tubing on fuel rail to attach the compression fitting. Using fine sandpaper, remove the paint from the end of the tube.
Re-install rails on intake. Follow
the swedgelok fitting instructions and install the fuel line. Use a rubber hammer or the palm of your
hand to gently bend the 90 degree fitting down slightly so that it clears your
engine covers. Install your clamp
and complete your installation. Before starting your car, pressurize your fuel system and check for
leaks. (see leak check/disclaimer sheet).