Passenger and driver side kits route your fuel lines behind your engine and allow the use of corvette injector covers. All stainless construction. Kits come with ss clamp, 24" hoses and 06 AN female ends unless otherwise specified. See custom hose section.

PRICE: 165.00

OR DRIVER SIDE

1. Remove fuel rails from engine.

2. Remove stock clamp from supply and return lines.

3. Remove the retaining clip from the fuel pressure regulator and pull out the return line.

4. Cut the supply line (see photo), 1 1/2" past fuel pressure port and install the new line following swedgelok fitting instructions included with this kit.

5. Loosen the tube nut that you just tightened and rotate the supply line to the position shown in the above photo.

6. Install the new return line in the regulator and position the line as in the above photo. Replace the retaining clip.

7. Install your fuel rails on your engine and adjust the positions of your 2 lines so that they will clamp to the rear intake manifold bolt.

8. Clamp the lines loosely and tighten the nut on the 90 degree compression fitting, then tighten your clamp.

9. Complete your fuel system and check for leaks. See leak check/ disclaimer sheet